Hi,
I've tried to load Quicksilver as stated in
http://scg.unibe.ch/research/quicksilver in a Pharo 4 image.
Apparently it was not correctly loaded because it expects Roassal "1"
to be loaded, but the ConfigurationOfQuicksilver loads Roassal2.
What should I do? Does anybody know of plans to migrate Quicksilver Roassal2?
Thanks,
Martín
On Wed, Sep 24, 2014 at 8:18 PM, Alexandre Bergel
<
[hidden email]> wrote:
> Yes, this is important!
>
> Alexandre
> --
> _,.;:~^~:;._,.;:~^~:;._,.;:~^~:;._,.;:~^~:;._,.;:
> Alexandre Bergel
http://www.bergel.eu> ^~:;._,.;:~^~:;._,.;:~^~:;._,.;:~^~:;._,.;:~^~:;.
>
>
>
> On Sep 24, 2014, at 12:56 PM, Mircea Filip Lungu <
[hidden email]> wrote:
>
> Hi guys,
>
> I don't know if anybody still counts, but I would like to announce another
> Masters thesis that was written while contributing to Moose:
>
> Dennis Schenk's work on Quicksilver
> (
http://scg.unibe.ch/archive/masters/Sche14a.pdf)
>
> Have a nice evening,
> M.
>
> --
> Mircea Lungu, PhD.
> Researcher
> Software Composition Group
> University of Bern
>
> _______________________________________________
> Moose-dev mailing list
>
[hidden email]
>
https://www.iam.unibe.ch/mailman/listinfo/moose-dev>
>
>
> _______________________________________________
> Moose-dev mailing list
>
[hidden email]
>
https://www.iam.unibe.ch/mailman/listinfo/moose-dev>
_______________________________________________
Moose-dev mailing list
[hidden email]
https://www.iam.unibe.ch/mailman/listinfo/moose-dev
Locked
